• Easy and quick application
• Quick single layer application in most cases, with no reinforcement required
• Fast curing, so suitable for most regions in the UK
• Seamless membrane with over 600% elongation
• Low temperature installation of -5
Ensure surfaces to be waterproofed are clean, dry and free of any rust, mould and contaminants such as oil, grease and dust.
Loose stone chippings must be removed and any cracks and splits in the substrate must be made good before installing the new waterproofing system. For all applications to single ply please contact the Easy-Trim Technical Services for more information.
Calculate the area to be covered by each unit before commencing any application. Apply using short, smooth lamb’s wool rollers, at a nominal rate of 1.25kg/m over the entire area and the detail work already completed.
All upstands must be reinforced using the Easy-Trim GFR 225, apply a coat of PolyureCoat at 1.25kg/m2. Easy-Trim GFR 225 (cut to size and 125mm either side of the junction). Pull through the PolyureCoat with a roller or brush on the surface. Add a further 0.25kg/m2 whilst still wet to fully encapsulate the GFR matting. Ensure this detail is continued on all the upstand.
The cure time is rapid so ensure the required application standard is achieved before moving on, as there is no time available to make corrections later. The whole roof area must be coated in PolyureCoat at the specified coverage rate, for full product guarantee.
IMPORTANT NOTE: The accelerant must be mixed at the exact ratio as supplied with the Polyurecoat. Not adhering to this ratio could lead to an incorrect mix and the product not curing properly.
Avoid overworking the solution when installing as the Polyurecoat is a self levelling compound. A completely waterproof skin will be formed after 30 minutes of installing the membrane and trafficable after 2-4 hours. Full curing time is 24 hours. PolyureCoat will not be damaged by a light shower 30 minutes after the installation, but a heavy shower could cause indentations in the membrane, which will only necessitate an additional layer of the membrane being applied for aesthetic purposes .
Packaging 6kg and 25kg tins
Accelerator 210ml (6kg) and 850ml (25kg)
Pot life 30 minutes (time from mixing to when it begins to dry or cure)
Application Roller, brush or spray.
Colours Dark Grey.
Storage 12 months in original, unopened and tightly closed containers, at temperature +5OC to 35C